The meters show the levels at the input and output of the EQ section.For the two filter bands, use the Response parameter to set the EQ type.Band 5 = High Cut (Low Pass) Filter or High Shelf. For Low/High Pass filters and Shelving filters, a high Q value will add a more defined bump at the frequency position resulting in a small boost or a more.Band 1 = Low Cut (High Pass) Filter or Low Shelf.To adjust each of the five bands, you can either touch and drag a numbered point on the EQ curve, or touch and drag the values inside the parameter boxes:.The EQ curve provides an easy way to check if the processing is turned on or off:.The EQ button acts as the master on/off for the complete section: 3-band parametric EQ + 2-band filters.So instead of a bell curve on one side you see a. The parameters for all five bands are shown simultaneously, and there is a visualization that shows the overall frequency response. A shelving EQ is different in that It affects all the frequencies on one side of the center frequency the same. Higher band - select either LPF (Low Pass Filter) or HiSh (High Shelf). Lower band - select either HPF (High Pass Filter) or LoSh (Low Shelf).On the second page, use the soft keys to set the EQ type for the filter bands:.To adjust the Q, press the + or – soft keys to increase or decrease the Q value.For the Gain/Freq controls: turn to adjust Gain press down and turn to adjust Frequency.This key appears in the same position on both pages. The EQ soft key acts as the master on/off for the complete section: 3-band parametric EQ + 2-band filters.Press down on the left (master) rotary control to toggle between the pages.There are two pages of parameters: one for the parametric EQ and one for the filters. Then adjust the parameters from either the surface or GUI. To access the parameters, press an Access key (on the fader strip) followed by EQ (on the Central Function Keys and/or GUI). Thus, there are two parameters that can be adjusted: gain (from -15dB to +15dB) and frequency (from 20Hz to 18kHz). In Low Shelf/High Shelf mode, the slope of the shelving EQ is defined by the gain value. The cut-off frequency can be adjusted from 20Hz to 18kHz. In High Pass/Low Pass mode, the filter slope is fixed at 12dB per octave. The following parameters can be adjusted:įor the 2-band filters, each band can operate either as a fixed slope filter (High Pass/Low Pass) or as a shelving EQ (Low Shelf/High Shelf). Each band can operate across the full frequency range and is set independently. There are three bands of parametric EQ: Low, Mid and High. The EQ section includes a 3-band parametric EQ plus 2-band filters. EQ processing is available for all sources.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |